Hey,
I have a big connector with some mechanical requirements. I want to figure out the mechanical spacing for some screw holes that are required, then move it onto the PCB, place, and route it without any of the parts changing position relatively. I would also like a visual outline of the card that will be plugged into my board so that I know where tall parts cannot be placed. I can group the parts into a new group, and I can (kind of) select them and move them relative to each other, but I can always move one of the parts separately if I click on it. To be honest, I can't really select them and move them as a group at all, the super filter selects any parts I highlight, not just the grouped ones. Also if I select the group, then try to use the move tool, it overwrites the group selection and prompts me to pick a part again before I can move. I don't want to do a lot of routing work only to realize that someone accidentally dragged a screw hole a few thou and everything needs to be ripped up.
Is there a way to group some parts together and move them relative to each other? Or is this impossible