I have a place replicate module of a circuit that works on one design bringing up a unknown error message when I apply it to a new design.
The modules was created in OrCad PCB 17.2 and error is showing up in OrCad PCB 17.2.
The error message "(SPMHDB-278): Module does not fit in design" shows up after I try to apply the replicate module to the parts. The layer matching never comes up and I am using the exact same circuit/parts. The original design used to create the replicate module did have more layers than the design its being applied to. However only etch shapes on the top were selected for the module.
Any help in explaining the probable meaning of the error code would be appreciated.